Hoshizaki F-330BAH(-C) Manual de usuario

®Hoshizaki“A Superior Degreeof Reliability”www.hoshizaki.comModelF-330BAH(-C)Self-Contained FlakerHoshizaki America, Inc.Issued: 5-4-2007Revised: 9-5-

10H. StartupCAUTION1. All parts are factory-adjusted. Improper adjustments may result in failure.. If the unit is turned off, wait for at least 3 min

11III. Cleaning and MaintenanceA. Cleaning and Sanitizing InstructionsIMPORTANTEnsure all components, fasteners, and thumbscrews are securely in place

16) Lift up the top insulation and unsnap the bin control assembly. Lift the assembly up through the insulation and set it aside. See Fig. 4.7) Remov

1319) When the gear motor starts, remove the front panel and move the ush switch to the "FLUSH" position to drain out the water from the ic

144) Remove the top panel.5) Remove the bin control assembly from the top insulation and set it aside. Remove the top insulation.6) Remove the thumbsc

15B. Maintenance IMPORTANT1. This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker.

16C. Preparing the Icemaker for Long Storage CAUTIONWhen the icemaker is not used for two or three days under normal conditions, it is sufcient to on

17HOSHIZAKI AMERICA, INC.618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A2SA10B

IMPORTANTOnly qualied service technicians should attempt to install, service, or maintain this icemaker. No installation, service, or maintenance sh

3CONTENTSI. Specications ... 4A. Na

4I. SpecicationsA. Nameplate Rating1. F-330BAH, F-330BAH-C See the nameplate for electrical and refrigeration specications. This nameplate is locate

5B. Dimensions/Connections1. F-330BAH, F-330BAH-CUnit = inches (mm)

6II. Installation and Operating InstructionsA. Checks Before InstallationIMPORTANT1. Install in accordance with all applicable national, state, and lo

7C. LocationCAUTIONThis icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +38°C

8• Drain line should not be piped directly to the sewer system. An air gap of a minimum of  vertical inches (5 cm) should be between the end of the d

9G. Final Checklist 1) Is the icemaker level?) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and