Hoshizaki KML-700MWH-M Manual de usuario

Hoshizaki“A Superior Degreeof Reliability”www.hoshizaki.comModelKML-700MWH-MLow-Profile Modular Crescent CuberHoshizaki America, Inc.Issued: 10-13-200

10F. Water Supply and Drain ConnectionsSee Fig. 4 or 5 WARNING1. Water supply and drain connections must be installed in accordance with applicable in

11Fig. 4KML-700MWH-M Connection to an Open Drain System2. Water-Cooled Condensera) Connection to an Open Drain System• Condenser water supply inlet is

1Condenser Return Line Shut-Off ValveCondenser Return Line Drain ValveIcemakerDrain Outlet 3/4" FPTIcemaker Water Supply Inlet1/" FPTFig.

13G. Final Checklist WARNINGCHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that

14H. Startup WARNING1. All parts are factory-adjusted. Improper adjustments may adversely affect safety, performance, component life, and warranty cov

15III. Cleaning and Maintenance WARNINGCHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after any cleaning or m

168) In bad or severe water conditions, clean the oat switch assembly as described below. Otherwise, continue to step 9.a. Remove the 3 screws securi

172. Sanitizing Procedure - Following Cleaning Procedure1) Dilute 1.5 . oz. (37 ml or .5 tbs) of a 5.5% sodium hypochlorite solution (chlorine ble

18C. Preparing the Icemaker for Long StorageCAUTION1. When storing the icemaker for an extended time or in sub-freezing temperatures, follow the instr

193) Open the condenser water supply line drain valve. If connected to a closed loop system, also open the condenser return line drain valve.4) Attach

IMPORTANTOnly qualied service technicians should install, service, and maintain the icemaker. No installation, service, or maintenance should be und

0HOSHIZAKI AMERICA, INC.618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A1HL10A

3CONTENTSImportant Safety Information ... 4I. Specicati

4Important Safety InformationThroughout this manual, notices appear to bring your attention to situations which could result in death, serious injury,

5MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKERWITHOUTSTORAGE

6B. Dimensions/Connections1. KML-700MWH-M (water-cooled marine)Unit: in. (mm)

7II. Installation and Operating Instructions WARNING1. This icemaker must be installed in accordance with applicable international, national, state, a

8C. LocationCAUTION1. This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within 45°F to 100°F (7°C to 38°C)

9E. Electrical Connection WARNING1. Electrical connection must be hard-wired and must meet international, national, state, and local electrical code r