Hoshizaki L1F015102 Manual de usuario

SELF-CONTAINED CRESCENT CUBERINSTRUCTION MANUAL KM-201BAHKM-260BAHKM-201BWHKM-260BWHL1F015102 (100109)

7C. LocationWARNINGThis icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +38°

8D. Electrical Connection WARNINGTHIS APPLIANCE MUST BE GROUNDED.This icemaker requires a ground that meets the national and local electrical code req

9 Fig. 2 Fig. 3Tapped Hole (Leg Mounting)Basefrom 6” (15.2 cm) to 7” (17.8 cm). Screw the legs tightly into the tapped holes

10* Drain lines should not be piped directly to the sewer system. An air gap of a minimum of 2 vertical inches (5 cm) should be between the end of th

11Water Supply Inlet1/2” FPTDrain Outlet3/4” FPTFig. 5KM-201BWHKM-260BWHCondenser Water Outlet 1/2” FPTCondenser Water Inlet 1/2” FPTShut-off ValveDra

12G. Final Checklist1) Is the icemaker level?2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and

13H. StartupCAUTION1. All parts are factory-adjusted. Improper adjustments may result in failure.2. If the unit is turned off, wait for at least 3 mi

14III. Cleaning and Maintenance InstructionsIMPORTANTEnsure all components, fasteners and screws are securely in place after any maintenance or cleani

157) After 30 minutes, move the Control Switch to the “OFF” position.8) Same as step 4.9) Move the Control Switch to the “ICE” position to fill the Wat

1617) Wash the Bin Control Switch, Water Tank, Float Switch, Cube Guide and Overflow Pipe by using a nylon scouring pad, brushes and the cleaning solut

IMPORTANTOnly qualified service technicians should install, service and maintain the product. No installation, service or maintenance should be undert

172) Soak the removed parts from step 17 above in a clean container containing the sanitizing solution. After allowing the parts to soak for 10 minut

18* The Storage Bin is for ice use only. Do not store anything else in the bin.* Keep the scoop clean. Clean it by using a neutral cleaner and rinse

195) Allow the line to drain by gravity.6) Attach compressed air or carbon dioxide supply to the potable water supply line Drain Valve.7) Move the Con

IMPORTANT1. This booklet is an integral and essential part of the product and should be handed over to the user. Read the warnings contained in this

1I. SpecificationsA. Nameplate RatingModel Amperes Refrigerant Energy StarKM-201BAH 6.1 AMPS R404A 12.0 oz. ApplicableKM-260BAH 7.6 AMPS R404A 12.7 o

2B. Dimensions/Connections1. KM-201BAHUnit: mm [inches]

32. KM-260BAHUnit: mm [inches]

43. KM-201BWHUnit: mm [inches]

54. KM-260BWHUnit: mm [inches]

6II. Installation and Operating InstructionsA. Checks Before Installation* Visually inspect the exterior of the shipping container, and any severe dam