Hoshizaki KML "F" SERIES Manual de usuario descargar pdf (Pagina 88)

PROBLEM POSSIBLE CAUSE REMEDY

[1] Icemaker will a) Bin Control 1. Set too cold. 1. Adjust warmer.

not stop when Thermostat 2. Defective. 2. Replace.

bin is filled

with ice.

[2] Abnormal a) Pump Motor 1. Bearings worn out. 1. Replace.

noise b) Fan Motor 1. Bearings worn out. 1. Replace.

2. Fan blade deformed. 2. Replace fan blade.

3. Fan blade does not move 3. Replace.

freely.

c) Compressor 1. Bearings worn out, or 1. Replace.

cylinder valve broken.

2. Mounting pad out of 2. Reinstall

position.

d) Refrigerant Lines 1. Rub or touch lines or other 1. Replace.

surfaces.

[3] Ice in storage a) Bin Drain 1. Plugged. 1. Clean.

bin often

melts.

PROBLEM POSSIBLE CAUSE REMEDY

[1] Small Cube a) Ice Cube Guide 1. Out of position. 1. Place in position.

Circulated water falls into

bin.

b) See chart 1 - [5], and check water supply line, Water Solenoid Valve, water system,

Pump Motor or Controller Board.

c) Drain Valve 1. Dirty. 1. Clean.

[2] Cloudy or a) See chart 2 - [1] and - [3], and check Float Switch, Water Solenoid Valve,

irregular cube Controller Board, Spray Tubes, water system, refrigerant charge or Expansion

Valve.

b) Spray Guide 1. Dirty. 1. Clean.

c) Water Quality 1. High hardness or contains 1. Install a water filter or

impurities. softener.

4. ABNORMAL ICE

5. OTHERS

For mechanical

bin control,

see “II. 4. [c]”

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 108 109

Sin comentarios

Hoshizaki KML "F" SERIES Manual de usuario Pagina 88