Hoshizaki KML "F" SERIES Manual de usuario descargar pdf (Pagina 35)

(Control Products HOS-001A Board)

The application switch located between relay X3 & X4 must be set to match the original

board application. Place this switch in the ALP position if there is no white wire supplied

to the K1 connector. If there is a white wire, place the switch in the C position. If this

switch is placed in the wrong position, either the compressor contactor will remain ener-

gized with the control switch OFF, or the unit will not start.

The dip switches should be adjusted per the adjustment chart published in the Tech

Specs book. Number 8 must remain in the OFF position.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 108 109

Sin comentarios

Hoshizaki KML "F" SERIES Manual de usuario Pagina 35