Hoshizaki STACKABLE CRESCENT CUBER KM-2100SWH3 Manual de usuario descargar pdf (Pagina 12)

If a Hoshizaki B-1300, B-1500, B-1650, or non-Hoshizaki bin is used:

g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the

thermostatextensionbracket(stainless).Usethe2screwstoattachthe"Z"bracket

(plastic) to the thermostat extension bracket (stainless).

h. Use the two 4×10 stainless steel screws in the accessory bag to attach the

thermostatbulbattachment(withattachedthermostatbulb)tothe"Z"bracket.

i. Remove the 2 screws from the lower part of the thermostat bracket (plastic) and use

them to attach the thermostat extension bracket (stainless) to the thermostat bracket

(plastic).

6) Level the icemaker and storage bin in both the left-to-right and front-to-rear directions.

Adjust the storage bin legs to make the icemaker level.

7) Replace the panels and baffle in their correct positions (unless you are installing a

secondunit).(See"E.InstallationofSecondUnit.")

E. Installation of Second Unit

1)See"II.D.Setup"forthelowerunitinstallation.

2) Remove the top panel and the top insulation of the lower unit. The top panel and the

top insulation of the lower unit are not required when installing the second icemaker.

3) Unpack the second icemaker (upper unit), and remove the shipping carton, tape, and

packing material.

4) Remove the panels of the second icemaker.

5) Stack the upper unit on top of the lower unit.

6) Secure the upper unit to the lower unit using the 2 mounting brackets and the bolts

provided.

Thermostat Bracket

(plastic)

Thermostat Bulb

Attachment (plastic)

"Z"Bracket(plastic)

Thermostat Extension

Bracket (stainless)

Fig. 5

Mounting

Brackets

Bolts

Bin

Icemaker

(Upper

Unit)

Icemaker

(Lower

Unit)

Fig. 6

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sin comentarios

Hoshizaki STACKABLE CRESCENT CUBER KM-2100SWH3 Manual de usuario Pagina 12